The Workflow

EagleWorks is the portal between your projects and the laser. We will go through the workflow in this section.

1. Import artworks or create shapes.
2. Lay out.
3. Set technology.
4. Check technology.
5. Laser processing.

Import Artworks or Create Shapes

If you make designs in 3rd-party drawing software, e.g. Illustrator, CorelDRAW, AutoCAD, Photoshop, etc, just import them into EagleWorks. Refer to Import Artworks for more details.

Or, you can create simple shapes directly in EagleWorks, i.e. lines, rectangles, circles, texts, etc. Refer to Create Simple Shapes for more details.

Lay out

Lay out, e.g. duplicate shapes as an array, nest shapes all over an area, etc. Refer to Lay out for more details.

Set Technology

The job will be prepared after setting technology, include cutting and engraving parameters, processing sequence, tool corrections, etc. Refer to Technology in EagleWorks for more details.

Check Technology

You can simulate the job in EagleWorks to check technology settings. Refer to Check Technology for more details.

Laser Processing

Now you can start the job either directly in the software or download and then control the laser on the panel. Refer to Laser Panel for more details.