Function Tests

In the main UI of the welding mode, you can do some basic function tests.

Function Tests
  • Assist gas test
    After the assist gas been turned on, you can click on the Blowing button to check whether the assist gas works properly.

  • Wire feeding test
    After the automatic feeder been turned on, you can click on the left or right arrow of the Feeder button to check whether the feeder works properly.

  • Chiller test
    After the chiller been turned on, you can check if there’s any alarm on it. If the water temperature is below 68 F (20 C), you should wait for the water to get warmer enough to enable the laser.

  • Laser test
    After the laser been turned on, you can check whether the laser works properly. First, click on the Wobble button to enable the galvo. Second, click on the Laser button to enable the laser. Third, click on the Lock button to set the machine to the READY state. Fourth, set the safety clip on the workpiece. Finally, aim the welding gun on the workpiece, press the trigger, and check if there’s laser firing on the workpiece.

Leave a Reply

Your email address will not be published. Required fields are marked *