Turn on the Laser System

Follow the steps below to turn on the EV-30 laser system.

1. Switch on the electrical power.

2. Turn on the voltage regulator.

   The exhaust(s) will be turned on automatically at the same time.

   
   

   
   

3. Turn on the chiller.

   IMPORTANT

   The fiber laser will NOT work if the water temperature is below 20°C (68°F). Turn on the chiller in advance to warm up if the ambient temperature is low.

   
   

4. (For 6kW only) Turn on the fiber laser.

   
   

5. Switch on the assist gas.

   
   

6. Turn on the main switch.

   Turn on the main switch on 3kW lasers.

   
   

   Turn on the main switch on 6kW lasers.

   
   

7. Release the emergency button.

   Release the emergency button on 3kW lasers.

   
   

   Release the emergency button on 6kW lasers.

   
   

8. Turn on the machine.

   Turn on the machine on 3kW lasers.

   
   

   Turn on the machine on 6kW lasers.

   
   

9. (For 3kW only) Turn on the fiber laser.

   
   

10. Turn on the computer.

    Turn on the computer on 3kW lasers.

    
    

    Turn on the computer on 6kW lasers.

    
    

11. Launch the CypCut software and complete the homing process.

    IMPORTANT

    The laser head will move to its home position (the front left corner of the cutting bed), make sure there is nothing blocking the way of the laser head and the gantry.

    IMPORTANT

    Cancel the homing process if there is any warning reported in CypCut.

    
    

Now the laser system is ready for machining.