Follow the steps below to set up your EV-30 laser system, and to be ready to get started.

  1. Get to Know the Components of the Laser System
  2. Get Prepared for the Installation
  3. Unpacking the Laser System
  4. Set up the Machine
  5. (For 3kW Only) Set up the Control Console
  6. (For 6kW Only) Set up the Control Console
  7. (For 6kW Only) Install the Fiber Laser
  8. Connecting the Chiller
  9. Connecting the Exhaust(s)
  10. Connecting the Voltage Regulator
  11. Connecting the Transformer
  12. Connecting the Assist Gas

Leave a Reply

Your email address will not be published. Required fields are marked *