Connecting the Chiller

  1. Connect the water hoses.

    Connect the low temperature water hoses to the fiber laser (pre-installed inside the machine for 3kW lasers, stand alone for 6kW lasers), and connect the high temperature water hoses to the machine.

    Connect the Water Hoses

    Connect the Water Hoses

    Connect the Water Hoses

    Connect the Water Hoses

  2. Fill up the chiller.

    Only purified or distilled water is allowed. And the chiller should be filled up to the green range of the water gauge.

    IMPORTANT

    Other types of water may corrode the pipeline inside the fiber laser, weakening the cooling effects.

    IMPORTANT

    Add antifreeze to cooling water to protect the fiber laser from freezing if the ambient temperature could be below 5°C (41°F). Otherwise, it may cause SEVERE DAMAGE to the core components of the laser.

    Fill up the Chiller

  3. Connect the alarm signal to the machine.

Leave a Reply

Your email address will not be published. Required fields are marked *