Unpacking the Laser System

Follow the steps below to unpack and place all the components of the EV-30 laser system, refer to The Recommended Footprint Configuration of the EV-30 Laser System for more details.

  1. Remove all the protective films and the packing materials on the machine, set it in place, and set all the accessory packs to the right side for now.

    The Machine Packing

    The Accessories Packing

  2. Remove the packing materials on the control console, and set it to the front of the left side of the machine.

    The control console for 3kW lasers.

    The Control Console Packing for 3kW Lasers

    The control console for 6kW lasers.

    The Control Console Packing for 6kW Lasers

  3. Remove the packing materials on the voltage regulator, and set it to the middle of the left side of the machine.

    The Voltage Regulator Packing

  4. (For 6kW only) Remove the packing materials on the fiber laser, and set it to the back side of the voltage regulator.

    The Fiber Laser Packing

  5. Remove the packing materials on the transformer, and set it to the front side of the voltage regulator.

    The Transformer Packing

  6. Remove the packing materials on the chiller, and set it to the rear of the left side of the machine.

    The Chiller Packing

  7. Remove the packing materials on the exhausts (only one exhaust for 6kw lasers), and set them to the back side of the machine.

    The Exhaust Packing

Leave a Reply

Your email address will not be published. Required fields are marked *