There should be something wrong with the USB communication if you get a “Communication Error” or “No Connected Device” error message in EagleWorks, and the laser machine is connected with computer by USB cable. Please follow steps below to diagnose…
Laser head would go back to programmed job origin by default on EAGLECAM / RDCAM powered laser machines. Sometimes, that would be a little boring, especially when the job origin is set on bottom left or bottom right of the…
RDCAM is a high performance control system embedded in laser machines, EAGLECAM is a customized version of RDCAM which support our premium EaglePrint print driver software. The control card has a configuration profile stored in it according to the laser…
Up to 19% Off
Flat shipping rate all over the mainland U.S.
$100/pc for 100W, $150/pc for 130W/150W
CO2 Laser Tube
Up to 19% Off
Flat shipping rate all over the mainland U.S.
$100/pc for 100W, $150/pc for 130W/150W
